AP Physics 2 · Lesson 11.10 · Unit 11 · CED topic 11.8 (RC circuits)

RC circuits

Name:   Date:  

1 Why this lesson matters

Read the opening paragraph and the "Learning objective · 11.8.B" box on the lesson page. In your own words, restate each idea below.

The time constant \(\tau = RC\) is a significant feature of an RC circuit and a measure of how quickly the capacitor will charge or discharge. For a charging capacitor, it is the time required for the capacitor's charge to increase from zero to approximately 63 percent of its final value; for a discharging capacitor, it is the time for the charge to fall from fully charged to approximately 37 percent of its initial value.

The potential difference across a capacitor and the current in its branch each change over time but reach a steady state after a long time. Immediately after being placed in a circuit, an uncharged capacitor acts like a wire.

After a long time, a charging capacitor is fully charged, at a maximum potential difference, with zero current in its branch. After a charged capacitor begins discharging, the charge and the stored energy decrease, and the charge, potential difference and current all fall until a steady state is reached.

After times much greater than the time constant, the capacitor and the circuit branch may be modeled using steady-state conditions.

Boundary: descriptions are limited to qualitative descriptions and representations. Students should be able to describe initial and final states mathematically, but are not expected to model the behavior mathematically with respect to time.

2 Charging a capacitor through a resistor

Read this section. In your own words, summarize the main idea.

3 Discharging

Read this section. In your own words, summarize the main idea.

4 The time constant

Read this section. In your own words, summarize the main idea.

5 Capacitors in circuits with several resistors

Read this section. In your own words, summarize the main idea.

6 Worked example

Read the "Worked example" box. Then, without looking back, try writing your own answer below.

A 12 V battery is connected through a switch to a 10 k\(\Omega\) resistor in series with an uncharged 100 \(\mu\)F capacitor. Describe the initial and final states and the time scale.

7 Sum it up

In two or three sentences, explain this lesson's main idea to someone who has not read it.